This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Read More
Deck Discs
Top side
Bottom side with eye hooks
Side
| Feature | Description |
| Diameter | 3.5" (88 mm) |
| Center Hole | 11/32" (0.34") |
| Features | Three concentric rings of 6 patent pending eyehooks. The 18 Eyehooks grip the membrane without initiating tears, and are easier to handle than barbs. High ribs and the extruded center hole provide increased strength. |
| Composition | High strength 20 gauge(0.9 mm) minimum AZ-50 Galvalume coated steel that meets the Factory Mutual 4470 criteria for corrosion resistance. |
| Packaging | 6 gallon (22.7 liter) buckets of 500 pieces each. Each bucket weighs approximately 52 lbs (23.5 kg). Can be sold individually. |
| Support | Superchute® provides technical support. Technical reps can advise the installer as to the correct installation method of the Superchute® Deck Disk. |
Debris Netting Brochure
PDF version
Screws
| HILTI HUS-H Anchor Screw (Heavy Duty Fastener) | |
| Head | Hex head |
| Diameter | 3/8" |
| Usable Length | 2-1/8" |
| Ultimate Load | 2" embedment In 4000 psi concrete: 4100 lb tension, 4475 lb shear |
| Reusable | No (Single use) |
| Hilti Code | • 336686 (1 box of 50 screws) • 305618 (12 boxes of 50 screws) |
| Notes | • Superior corrosion resistance, 240 hour salt spray • Removal will not damage the base material or the deck disc • Threads cut into the base material, tapping the concrete, brick or block |
| Drill Bits | • Pre-drill a 5/16" diameter hole, preferably with a HILTI TE 6-S Rotary Hammer Drill • Recommended drill bit: HILTI TE-C3X 5/16" x 6" bit (4" usable) • HILTI drill bit codes: 206671 (1 bit) or 226968 (6 bits) |
| Tapcon Screw (Light Duty Fastener) | |
| Head | Hex head with slot |
| Diameter | 1/4" |
| Usable Length | 1-1/4" |
| Ultimate Load | |
| Reusable | No (Single use) |
| Hilti Code | Sold Individually |
| Notes | • Superior corrosion resistance • Removal will not damage the base material or the deck disc • Threads cut into the base material, tapping the concrete, brick or block |
| Drill Bits | Pre-drill a hole using a 3/16” masonry bit |